Below, you’ll find the AlienVault Open Source SIEM Installer. Using any host (even a virtual machine), this installer will erase and partition the disk and install everything you need to get an AlienVault Open Source SIEM up and running in under ten minutes. This installer includes all the software as well as the operating system – so you don’t need to install the components separately.

You need only supply an IP address for the host, the listening interface, and a password. Everything else will be taken care of. After the installation, simply point your browser at the selected IP and start enjoying your brand new SIEM. IDS, Network Monitoring, Availability Monitoring, Vulnerability Scanning, Anomaly detection, Inventorying, and a powerful correlation engine centralizing everything will be optimally pre–configured.

AlienVault OSSIM Installer
The standalone installer, use this if you're installing a system from scratch. Burn it and boot into the installer.

v2.3.1 (64bit edition)

v2.3.1 (32bit edition)

For more detailed information about the enhancements to the AlienVault SIEM family, please follow the link below to view content created to illustrate these new capabilities available in version 2.3: Online Presentation: What's New in OSSIM 2.3?

If you’re upgrading, please read these release notes carefully. Upgrade is straightforward but there are a couple of important things to be aware of.

Old versions

Source Code