Documentation Center
AlienVault® USM Appliance™

Microsoft DHCP Server through NXLog

When you configure Microsoft DHCP Server to send log data to USM Appliance, you can use the DHCP Client Service NXLog plugin to translate the raw log data into normalized events for analysis.

Device Details
Vendor Microsoft
Device Type Client Service
Connection Type Syslog
Data Source Name dhcp-nxlog
Data Source ID 1584

Integrating Microsoft DHCP Server and NXLog

Before you configure Microsoft DHCP Server to send logs to USM Appliance through NXLog, you must have the IP Address of the USM Appliance Sensor.

Configure NXLog on Windows

To send log data through NXLog to USM Appliance

  1. If not done already, download nxlog.conf, and then place it in the conf directory of your NXLog installation. Depending on which version you use, the directory can be C:\Program Files (x86)\nxlog\conf for the 32-bit version or C:\Program Files\nxlog\conf for the 64-bit version.

    Note: This step overwrites the default nxlog.conf file. You may want to back up the original copy before placing the one provided by AlienVault.

  2. Open the nxlog.conf file in a text editor.
  3. Update the ROOT path of your NXLog installation.

    1. Locate the following lines

      #define ROOT C:\Program Files\nxlog

      #define ROOT C:\Program Files (x86)\nxlog

    2. Uncomment the path that matches the NXLog installation on your Windows machine.
  4. Enter the USM Appliance Sensor IP address.

    1. Locate the following line

      define OUTPUT_DESTINATION_ADDRESS <USM-Appliance-Sensor-IP>

    2. Replace <USM-Appliance-Sensor-IP> with the IP address of the USM Appliance All-in-One or USM Appliance Sensor that will receive the Windows events.
  5. Uncomment the section between DHCP-NXLOG and /DHCP-NXLOG.

    Important: Only remove the first # symbol in each line when uncommenting the sections. The remaining # symbol indicates that the line is either a comment or optional.

  6. In addition, uncomment the following lines, above the DHCP-NXLOG section:

    #<Extension json>

    # Module xm_json

    #</Extension>

  7. Save the file.
  8. Start or restart the NXLog service.

Plugin Enablement

For plugin enablement information, see Enable Plugins.

If enabling the plugin on assets, you will find it listed as Microsoft : DHCP Client Service : NXLog.

Enabling the dhcp-nxlog plugin from asset

Additional Resources and Troubleshooting

NXLog documentation on forwarding and storing logs

For troubleshooting, refer to the vendor documentation:

NXLog documentation on troubleshooting