Documentation Center
AlienVault® USM Appliance™

Motorola RFS 4000

When you configure Motorola RFS 4000 to send log data to USM Appliance, you can use the Motorola RFS 4000 plugin to translate the raw log data into normalized events for analysis.

Device Details
Vendor Motorola
Device Type Router/Switch
Connection Type Syslog
Data Source Name Motorola RFS4000
Data Source ID 1901

Integrating Motorola RFS 4000

Before you configure the Motorola RFS 4000 integration, you must have the IP Address of the USM Appliance Sensor.

To configure Motorola RFS 4000 to send Syslog messages to USM Appliance

  1. Access the Motorola console terminal and enter the configuration mode by typing the following:

    > configure terminal

  2. Enter the following commands on the command line:

    > logging on

    > logging aggregation-time <1-60>

    > logging [syslog] [<0-7>|alerts| critical|emergencies|errors|informational| notifications|warnings]

    > logging host <USM Appliance IP address>

    where:

    • on: Enables the logging of system messages.
    • aggregation-time <1-60>: Sets the number of seconds for aggregating repeated messages. The value can be configured between 1 and 60 seconds.
    • syslog [<0-7>|alerts| critical|debugging| emergencies|errors| informational| notifications|warnings]: Sets the syslog server logging level.
    • host <USM Appliance IP address>: Configures a remote host to receive log messages.

Plugin Enablement

For plugin enablement information, see Enable Plugins.

Additional Resources and Troubleshooting

http://documentation.extremenetworks.com/ExtremeWireless/WING_CRG_72E-139342-01_REVA_EN.pdf

For troubleshooting, see the vendor documentation.