When you configure Netwrix Auditor to send log data to USM Appliance, you can use the Netwrix Auditor plugin to translate the raw log data into normalized events for analysis.
|Device Type||Infrastructure Monitoring|
|Data Source Name||netwrix-activity-nxlog|
|Data Source ID||1920|
Integrating the Netwrix Auditor Add-on for AlienVault and NXLog
Netwrix provides a free add-on for AlienVault to integrate Netwrix Auditor with USM Appliance through the RESTful API. Before configuring NXLog, you must first use the add-on to generate special Windows event logs for USM Appliance.
Configure the Netwrix Auditor Add-on for AlienVault
If you haven't already, download the add-on from the Netwrix website. Follow the detailed instructions in their Quick-Start Guide to install and properly configure the add-on. Make sure you have reviewed the events generated by the add-on, as documented in section 3.6 of the Quick-Start Guide.
To send log data through NXLog to USM Appliance
If not done already, download nxlog.conf, and then place it in the conf directory of your NXLog installation. Depending on which version you use, the directory can be C:\Program Files (x86)\nxlog\conf for the 32-bit version or C:\Program Files\nxlog\conf for the 64-bit version.
Note: This step overwrites the default nxlog.conf file. You may want to back up the original copy before placing the one provided by AlienVault.
- Open the nxlog.conf file in a text editor.
Update the root path of your NXLog installation.
Locate the following lines:
#define ROOT C:\Program Files\nxlog
#define ROOT C:\Program Files (x86)\nxlog
- Uncomment the path that matches the NXLog installation on your Windows machine.
Enter the USM Appliance Sensor IP address.
Locate the following line:
define OUTPUT_DESTINATION_ADDRESS <USM-Appliance-Sensor-IP>
- Replace <USM-Appliance-Sensor-IP> with the IP address of the USM Appliance All-in-One or USM Appliance Sensor that will receive the Windows events.
Uncomment the section between NETWRIX-NXLOG and /NETWRIX-NXLOG.
Important: Only remove the first # symbol in each line when uncommenting the sections. The remaining # symbol indicates that the line is either a comment or optional.
- Save the file.
- Start or restart the NXLog service.
For plugin enablement information, see Enable Plugins.
If enabling the plugin on assets, you will find it listed as Netwrix : Netwrix Auditor : -.
Additional Resources and Troubleshooting
For troubleshooting, refer to the vendor documentation: