Documentation Center
AlienVault® USM Appliance™

Untangle NG Firewall

When you configure Untangle NG Firewall to send log data to USM Appliance, you can use the Untangle NG Firewall plugin to translate the raw log data into normalized events for analysis.

Device Details
Vendor Untangle
Device Type Firewall
Connection Type Syslog
Data Source Name Untangle-NGFW
Data Source ID 1843

Integrating Untangle NG Firewall

Before you configure the Untangle NG Firewall integration, you must have the IP Address of the USM Appliance Sensor.

To configure Untangle NG Firewall to send Syslog messages to USM Appliance

  1. From the Untangle Administration interface, select Reports Settings > Syslog.

  2. Configure the following options:
    • Host: Enter the USM ApplianceIP Address.
    • Port: 514
    • Protocol: This is the protocol used to send syslog messages. UDP is the default protocol.

Plugin Enablement

For plugin enablement information, see Enable Plugins.

Additional Resources and Troubleshooting

https://wiki.untangle.com/index.php/Reports#Syslog

For troubleshooting, refer to the vendor documentation:

https://support.untangle.com/hc/en-us/articles/200683678-Troubleshoot-throughput-through-NG-Firewall