• Support
  • Forums
  • Blogs

Vulnerability scans produce empty results

VOXDATAVOXDATA

Entry Level
+2

I recently upgraded from version 3.1 x86 to 4.3 x64, and normally i would enter a subnet to scan with a /24 and away Alienvault would go. In this version (4.3), after i run a scan job it terminates after less than a minute. It seems like nothing was found. 

In my asset inventory, all stations on the subnet are displayed with nagios enabled for each station. However the vul scan doesn't seem to find anything?

This version of alienvault is usig the same IP as its predecessor, so i know its not a network related issue.

Can someone help me out here.

THX.

Share post:

Answers

  • Hi guys! I faced the same issue. I tried both method but still unable to solve the issue of the scan taking only 1 minute with no result at all.
This discussion has been closed.